1/16-DIN PROCESS 1/16-DIN PROCESS CONTROLLER CONCISE PRODUCT MANUAL (59222-4) CAUTION: Installation and configuration should be performed only by personnel who are technically-competent and authorised to do so. Local Regulations regarding electrical installation & safety must be observed. INSTALLATION Panel-Mounting The mounting panel must be rigid and may be up to 6.0mm (0.25 inches) thick.

Honeywell eZtrend Paperless Recorder. Honeywell eZtrend Paperless Recorder X SERIES - ADVANCED GRAPHIC RECORDER Data Storage &bull Hengstler grado 921 1 / 4 DIN Temperature Controllers. File:Gilbarco-veeder-root.svg - Wikipedia; What's the Connection? Hengstler Grado 921 Manual Dexterity - eainternet; Meet Fortive, Danaher's New Industrial Company.

Torrent Soft Cell Discography there. The cut-outs required for the Controllers are shown on the right. Controllers may be mounted side-by-side in a multiple installation for which the cut-out width (for n Controllers) is (48n-4)mm or (1.89n - 0.16) inches For panel-mounting, see below.

CAUTION: Do not remove the panel gasket; it is a seal against dust and moisture. Rear Terminals UNIVERSAL INPUT Linear (mA) OUTPUT 1 Linear (V/mV) Relay N/O C N/C Thermocouple Mounting panel Controller Housing Solid State Ratchets Gasket RTD USE COPPER CONDUCTORS (EXCEPT FOR T/C INPUT) Single strand wire gauge: Max. 1.2mm (18SWG) Relay N/C C N/O DC/SSR Drive 1 16 17 18 2 3 4 5 6 OUTPUT 3 TOP 13 14 15 OUTPUT 1: Always primary control (HEAT) output - Relay, SSR Drive, Solid State or DC. OUTPUT 2: Secondary control (COOL) output - Relay, SSR Drive, Solid State or DC.

Alarm Output - Relay, SSR Drive or Solid State. OUTPUT 3: Alarm Output - Relay or SSR Drive. Recorder Output - DC only for setpoint or process variable. Input/Output Type Selection To access the link jumpers, REMOVE ALL POWER, grip the side edges of the front panel and pull the Controller out of the housing, noting its orientation. To replace, align the CPU PCB and PSU PCB (see right) with their guides in the housing, then slowly push the Controller into position.

7 8 9 10 11 12 Slide mounting clamp over Controller housing towards rear face of mounting panel until tongues engage in ratchets and Controller is clamped in position. Hold Controller firmly in position (apply pressure to bezel only) 100 - 240Vac 50/60Hz 20 - 50Vac * 50/60Hz 22 - 65Vdc * L N A B COMMS SERIAL RS485 45mm +0.5 -0.0 No external connections to be made to these terminals.